We provide
bulk orders for our products. Whether you're a contractor, electrician or builder, we want to be your supplier of
quality products at competitive prices. We believe in customer satisfaction! We provide fast shipping and also have the best customer service in the industry! Please feel free to contact us at 647-350-8898 if you need any assistance with the price.
Model
DR35RB-WH/BK/SN
Features
20° Tilting
High Performance
Easy Installation
FT6 Cable
5CCT Switchable
10%-100% Continuously Dimmable
5 Years Warranty
Specs Sheet
Cut-Size: 3-1/2″
Wattage: 9W
Input: 100-120V AC, 60Hz, 0.09A
Beam Angle: 38°
Lumens: 650LM
CRI: 90+
5CCT: 2700K/3000K/3500K/4000K/5000K
Power Factor: 0.98
Light Source Life (hrs): 36,000
Type IC: Yes
Airtight: Yes
Damp Location: Yes
Wet Location: Yes
Type IC Rated for direct contact with insulation.
Assembly Instructions:
1.Risk of electric shock- turn off power before inspection, installation or removal.
2.Locate a suitable position to place the LED fixture and open a hole in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
3.Run the electrical wire from the switch (power supply), through the mounting hole-use NMD90 OR BX cable.
4.Open the hardwire box swing cover and remove the appropriate knockout(s).
5.Insert the electrical supply cable through the knockout.
6.Wire box using supplied quick connect push-in terminals. Connect green ground wire of cable to green wire of box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box.(Fig. 1).
7.Place all wiring and connections back into the box and close the cover.
8.New construction applications: Junction box shall be firmly secured to studs, joists, or similar fixed structural units.(Fig.2)
9. Remodel applications: Do not require the junction box to be firmly secured after the mounting plates, studs, joists, or structural units that have been concealed. Snap off the junction box tabs(Fig.3), then insert into ceiling(Fig.4).
10.Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling(Fig.5).
11.Once assembly is complete, turn on power to confirm fixture is working properly.
Hole Cut Size:∅4-3/32"104mm
Tools Required:
Saw
Measuring Tape
Electrical Wiring (use type and gauge suitable for application to connect the fixtures).
SAFETY: For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
Warning: Make sure power is OFF from the electrical panel before starting installation or attempting and maintenance. For indoor installation only.
For WET location applications, after fixture is installed on ceiling, put silicone glue to seal the gap between fixture and ceiling.